The Process of Paving

At SA Paving we believe in using the correct equipment to get the job done, you can well imagine how much cutting will need to be done to ensure a custom fit.

We only use angle grinders to ensure that the paving is cut with the utmost precision, leaving you with a neat and aesthetically pleasing final product.

Our specifications are laid down by the Master Builders Association (MBA), protecting your rights in the process.

We are proud of our concrete edge restraint as we are the ONLY paving company that utilises steel to reinforce the edge beam, ensuring the highest standard of quality.
This procedure is vital to the stability of your project and must be done correctly.

Our edge beam is constructed below the header course (border brick) of your paving to a thickness of 60mm.
Brick force is then inserted in the middle of the edge beam, ensuring maximum strength.

Our continual desire to innovate and improve has given us the EDGE!

A mixture of plaster sand and cement is used to grout butt joint paving.
This process ensures that the joints between the pavers are well sealed.

Once the plaster sand and the cement have been well mixed, it is then evenly spread across the paving.
A plate compactor is then used to ensure that the grouting fills all the joints between the pavers.
All excess is then lightly hosed off the surface to ensure that no cement is left behind.

Our innovative, one of a kind quick drying cement additive allows for motor access after only 24 hours, instead of the usual 5 days.
For added protection and colour enhancement our sealer is offered as an optional extra.

Ants unfortunately could pose a problem in the long term as their 'eat through anything' attitude applies to the grout, but good product advice from your local hardware store will effectively and efficiently solve any and all ant problems you may have.